Nylon Wear Strip

Nylon Wear Strip

The nylon wear strip is a long strip of wear-resistant material made from a nylon base, typically embedded or fixed on the sides of conveyor tracks, guide rails, or chutes to guide workpiece movement and reduce sliding friction.
Send Inquiry
Description

Unlike block-shaped pads, this nylon wear strip is distributed continuously in long strips, suitable for guide surfaces on long straight sections or large-radius curves. Its cross-section is often rectangular, U-shaped, or custom-profiled, fixed to the metal frame via back slots or countersunk bolts. Under repeated friction from chains or sliders, the strip surface remains smooth, preventing direct metal wear.

 

Application Scenarios

 

Application Position

Typical Guide Component

Matching Features

Overhead Chain Track Sides

Chain push dogs or guide wheels

Long-distance continuous friction, requires oil resistance and noise reduction

Skid Guide Rails

Skid side guide wheels

Bears lateral thrust, prevents metal frame wear

Material Chutes or Sorting Lanes

Cartons or pallet sides

Provides smooth transition, prevents packaging edge jamming

 

After-Sales & Technical Support

 

1.jpg

After-Sales & Technical Support
Warranty & Replacement: 12-month warranty from shipment. Free replacement for abnormal wear caused by material defects (bubbles, delamination, brittle fracture); failure due to overload, over-temperature, or missing expansion joints is not covered.
Wear Assessment: Replace when surface wear depth exceeds 2mm or uneven wear/cracking appears; locally worn sections with vertically symmetrical cross-sections can be removed and flipped for continued use.
Installation Guidance: Reserve 2-3mm expansion joints per meter for long-distance laying to prevent arching and chain jamming from heat expansion; for low-temperature environments (outdoor/cold storage), recommend PA12 or modified PA66 toughened materials and increase support point density.
Spares & Support: Customization of straight, arc, and special cross-sections per drawings, batch delivery per project, plus remote installation guidance and wear cause analysis.

FAQ

Q: What should be done if the middle section of the nylon wear strip shows fuzzing or grooves after long-distance use?

A: This is normal friction wear. If groove depth affects running stability, flip it if the cross-section is vertically symmetrical, or replace it directly. Daily sanding of fuzzy areas reduces slider resistance.

Q: How to prevent the nylon wear strip from arching and falling off due to thermal expansion and contraction?

A: Reserve appropriate expansion gaps during installation, or use segmented splicing with end pressure plates. For countersunk bolts, slot the holes to allow slight sliding in the length direction.

Q: Will the nylon wear strip become brittle and break in low-temperature cold storage?

A: Ordinary nylon loses toughness at low temperatures. Use low-temperature modified nylon (e.g., PA12 or with toughening agents) and avoid excessive pre-stress during installation.

 

 

 

 

Hot Tags: nylon wear strip, China nylon wear strip manufacturers, suppliers, factory, braided nylon flex tubes, m6 nylon threaded rod, nyloil sheet, nylon 66 bar, nylon air line tubing, oil filled nylon rod